[Ikerman]

One of the problems I had trouble with is upside down primers that don't get rejected at the second rejection point at the clear plastic plate (A in this case). The problem was the clear plastic plate seemed to be warping or torking slightly upward, allowing the out of position primers to pass. I found a solution to the problem by inserting a small spring on top of the clear plastic plate and retained by the plastic cover. The spring puts slight pressure on the clear plastic plate to hold it down firmly, thus causing proper rejection of the mis-positioned primers. It is possible to glue the spring to the top of the clear plastic plate if necessary or convenience.
 Dillon_Primer_Loader.JPG (41.63K)
Number of downloads: 100

This post has been edited by Ikerman: 07 November 2009 - 05:36 AM