Brian Enos's Forums... Maku mozo!: New EAA Witness 10mm - Brian Enos's Forums... Maku mozo!

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

New EAA Witness 10mm Springs for 10mm

#1 User is offline   Sal Jr 

  • Looks for Range
  • Pip
  • Group: Members
  • Posts: 1
  • Joined: 06-June 09

Posted 06 June 2009 - 11:02 AM

Just purchased a new full size 10mm EAA Witness. After reading a few forums, I decided to purchase the following springs from Hennings shop for my new gun(see below). I will be using High velocity AMMO as a standard. Am I on the right track?

Wolff Extra Power Extractor Spring Tanfoglio / EAA

W49820 Wolff Recoil Spring 20lb Tanfoglio / EAA




Sal in Alaska.

Attached File(s)



#2 User is offline   Gary1911A1 

  • Sees Sights Lift
  • PipPipPipPip
  • Group: Classified
  • Posts: 395
  • Joined: 19-June 06
  • Gender:Male
  • Location:Ohio for now

Posted 06 June 2009 - 04:42 PM

Yes, I also use a Buffer Technology Recoil Buff for the CZ 75 to cushion the slide impact and a stronger mainspring that helps to slow unlocking. I wish somebody would make a Firing Pin Stop for the EAA with a flat bottom like EGW does for the 1911 that could also slow unlocking, but nobody seems interested.

Sprinco also makes a unit for the Witness in 10MM.

This post has been edited by Gary1911A1: 06 June 2009 - 04:43 PM


#3 User is offline   bubbadoc 

  • Finally read the FAQs
  • PipPip
  • Group: Classified
  • Posts: 52
  • Joined: 24-January 09
  • Gender:Male
  • Location:Fort Worth

Posted 07 June 2009 - 08:51 AM

Sal Jr-
I did the same for mine. Shot some rounds at first with the factory rigging.... I think it is best to change immediately as the EAA seems to be from the factory a little lightly sprung....

K

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users