Need a 38 load
Posted 13 April 2012 - 06:53 PM
Posted 14 April 2012 - 05:29 AM
New to ICORE,need a load for 38 sp. Any help is appreciated,Dave.
158 LRN with 3.2 gr of CLAYS. Clean and soft. In some guns it may be too soft (sub minor). But, still a good load.
Posted 18 April 2012 - 09:24 PM
USPSA Member: A-62520
Posted 20 April 2012 - 07:59 PM
158 gr Bear creek Moly LRN
Federal SP primers
4.2 gr will make minor in a 6" gun
4.6 gr will make minor in a 4" gun
Posted 13 May 2012 - 02:49 AM
Posted 02 June 2012 - 04:42 PM
Throw about 3.7grs of WST under those bullets and call it good.I ended up sending a few of my LRN/WST loads out with a local shooter to IRC because they grouped so well at 50.-Mike
How about a load for accuracy with the .38 special using 160 gr. Bayou bullets out to the 50 yard shots with a 627vcomp. Thanks
"If at first you don't succeed,then maybe skydiving wasn't for you"
Posted 17 July 2012 - 06:53 AM
I use 5.1 of WST in 38spl brass with a Zero 125 hollow point, or a 125 XTP hollow point.
Power factor is 128, makes it for Action Pistol and IPSC. ( minor power factor )
The 2 guns are a 681-c and a 686 preformance centre both with 6" barrels.
The load is flat shooting and at 50yrds the rounds go through the same hole if im lucky.
Forgot to add, Federal Small Pistol Primers, my Revolvers will not set off the others, to hard.
Hope this helps.
Edited by JRB, 17 July 2012 - 03:36 PM.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users