Kend,
Am having problems installing the magwell (IDPA-legal) on my M&P Pro 9mm. I am having difficulty lining up the holes to run the pin thru. Any trick to this or suggestions? Thanks
Need Help Installing Magwell
Started by
The_Vigilante
, Jan 21 2011 06:11 PM
1 reply to this topic
#1
The_Vigilante
-
- Classifieds
-
- 1,686 posts
Beyond it All
- Gender:Male
- Location:El Paso, Texas
Posted 21 January 2011 - 06:11 PM
The_Vigilante
"A man can never own enough guns or ammunition!"
The Ultimate Zombie Solution: Dead Reckoning
"A man can never own enough guns or ammunition!"
The Ultimate Zombie Solution: Dead Reckoning
#2
SixShooterPerry
-
- Members
-
- 18 posts
Looks for Range
- Gender:Male
- Location:New Tripoli PA
Posted 21 January 2011 - 06:51 PM
I used a drill bit that was slightly smaller in dia. to line up the holes before pushing the pin through. I also slightly rounded the pin at the ends to take the sharp end off. This might work for you.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
